|
|
|
IS46 Pattern Select Touch Switch |
The IS46 is touch sensitive switch for pattern control. Its wide selection of color frames allows it to match any decor or motif. It easily replaces existing wall switches as it is based on standard European wall switch dimensions. Wiring is also very simple as it only requires one phone cable to serve as both its data interface and power supply.
|
|
The K80 is a dimmer driver especially designed to be used with the LT4500, but can also be used with classic switches with regular classic switches just like ordinary dimmer drivers.
What makes them unique is their ability to smoothen any brightness changes by gradually fading the light in and out to allow the eye to slowly adjust.
The K80 is suitable for dimming halogen, incandescent and certain AC dimmable LED lamps.
|
The ACS50 is among the most appealing of the products in the SLCS catalog. It has a touch panel interface and a D-Bus interface. It comes in a selection of 3.5" or 5.7", and may be installed onto a control panel.
The ACS50 can be likened to a bunch of virtual switches arranged into pages, e.g. 1F, 2F and so on. Each switch can be labeled with a descriptive name and shows the status of its associated switch in real time, with an audible feedback when a switch is pressed.
One can even place a floor diagram or an elevation diagram for more convenience in use.
|
|
The CC1000 is a D-Bus for the SLCS that automatically polls and collects data from the various LT and sends them to the central host as requested. The CC1000 uses the Modbus protocol, as it is the standard and most commonly used protocol used in facility management. Thus, it can easily be interfaced to a BAS or SCADA system.
The CC1000 connects both ways, it can report the status of all the LT devices connected to the D-Bus, and also relay the commands from the central host to the desired LT device. The CC1000 has a fast response time, in the order of 0.2 seconds, allowing real time data updating and control.
The CC1000 supports both RS232 and RS485 as its communication interface to the central host. It has on-board communication LED indicators which helps during installation and testing. It does not require a separate power supply as it can be directly connected to a 110V or 220V AC source.
|
|
LT4500 Digital Dimmer Controller |
The LT4500 is an LTU (load terminal unit) of the SLCS series that is designed specifically for use with LED dimmers or fluorescent light dimmable ballasts.
The LT4500 has 4 channels of 0 to 10V analog outputs which can be used to control dimmable ballasts and 4 matching 0 to 10V analog inputs for connecting with dimmer switches.
|
|
|
|
|
<< Start < Prev 1 2 Next > End >>
|
|
Page 1 of 2 |
Home Lighting Control System (2.1MB)
